Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kpsingh
No of port:5 and No of Position (Plunger):2.Five ports means, 01 i/p (air supply in), 02 o/p (one o/p port will send air while other remain close and the function will change when coil will energize) and 02 exhaust port (will exhaust the air when coil will de-energize).Two position means plunger is either up (openes the line) or Down (closes the line)
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
1.what is the power consumption of three element drum level control in sugar industries? 2.how to reduce that?
how pressure transmitter work, what is its principal to measure and how its generate signal. for pressure transmitterinstallation which precautions must be taken ??
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
what is isloted barrier how it works and what are the main purpose.how it make safe area.
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
Do you have reference list?
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
what is the procedure of O2 sensor(ABB) calibration?
What are continuances of connecting earthing and shield of branch cables (instrument to Junction box), at the same earthing pot provided on JB? Is it ok, or may produce some problem?
What is Droop? What is Step/Gradient Limiter in Turbine Governor control?
Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
what is intrinscily safe system and where we use?
