Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / yogendra sahu
5/2 it means 5 port 1 inlet 2 outlet 2 exst
/2 it means 2 position open or close
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?
what is stroke check for field instument transmetter's & AOV's
Explain the difference between plc and cnc?
what is cold loop? difference between hot and cold loop?
what deference between panel earth and systemearth
where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
what is your eligibility criteria for freashers?
What is sensitivity in vibration probes..?
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
how to calibrate corollaries (Mass flow meter)?
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
