Answer / ramdas a. wani

I have checked the correct answer. The creep valves are
safety valves installed in gas lines downstream of the PCV
( pressure control valve ) When the PCV is unable to
maintain the downstrem pressure and it exceeds a set limit
the creep safety vlave releives the excess pressure and
maintains the line pressure.
The defination is also given in the petroleum and natural
gas regulatory board notification of 2006 ( 19 of 2006)

Answer / millan

A relief valve which is installed and sized to protect
against the build up of downstream pressure due to a
regulator's failure to lock up. This type of relief is not
full fault protection.

Answer / jain2704

INSTRUMENTATION

what is the difference between 2 wire and 3 wire RTD- application wise,cost effectivity?

2 Answers  

---

what is isloted barrier how it works and what are the main purpose.how it make safe area.

0 Answers  

---

For 150 mtr cable run from DCS panel to transmitter (24 VDC with 4-20 ma output), need cable size. 1.5 sqmm is suitable?

2 Answers   NA,

---

what is the difference between E/P positioner and I/P positioner in control valve , in which application the respective positioner are used in.

1 Answers   ABB,

---

how to check diode wheather it is working or not by using multimeter?

3 Answers  

---

What is Positive Calibration and Negative Calibration?

0 Answers   SA Kent,

---

In control valve there are two type of valve seat we can use metal to metal seat & soft seat.On this valve seat i have following doubt. 1)I have never seen practically the internal assembly of valve so my doubt is that basically weather the seat is soft seat or metal its basic MOC is same as valve body(SS or CS) only in soft seat we are using PTFE ring & place on valve seat & in metal this PTFE ring is not threr am i correct??????? 2)what are the common general rule for using metal to metal seat & soft seat,means its depend on process parameter like liquid,gas, steam & on valve leakage class.

1 Answers  

---

flow transmitter range is 0 -500 mmwcc but the transmitter shows 12 ma for o mmwc instead of 4 ma ...how to solve this problem when we apply 375 mmwc it shows 16 ma

3 Answers  

---

What does threshold mean? what does tolerance mean?

1 Answers   DEWA,

---

Describe the typical instrumentation used in monitoring the performance of a shell and tube heat exchanger.

0 Answers  

---

How a pH sensor & analyzer work at waste water treatment plant, whats the principle & science is beyond this,How pH sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in analyzer

1 Answers  

---

what is vfd(variable frequency drive)?type of vfd.

2 Answers  

---