Answer / greenborhan

Boiler is a machine/device whose main function is to generate steam from water for using various purposes in power plant as well as many other industries.
1. In power plant steam is used to move turbine blade.
2. In different plants steam is used for evaporation such as making Caustic Flakes from liquid caustic, in H2O2 plant steam is used for increasing the concentration of H2O2, in sugar mills steam is used for making sugar flakes from liquid sugar, in paper mills and textile steam is used on dryer for drying paper and clothes respectively so on.............

Answer / sachinbaindal48

BOILER IS ALSO KNOWN AS STEAM GENERATOR.IN WHICH THE HEAT IS
PRODUCED WATER IS CONVERTED INTO STREAM.THERE ARE COALS IS
USED AS FUEL.THEN THESE STEAM SEND TO THE GENERATOR AND
GENERATOR IS A DEVICE WHICH CONVERTS MECHANICAL ENERGY INTO
ELECTRICAL ENERGY.

Answer / greenborhan

We generally use gas and diesel as burner's fuel in Bangladesh.
Some of our burners are designed for gas, some are for gas but most of our burners are designed for both gas and diesel i.e. we can use both gas and diesel as burner's fuel.
grenborhan@gmail.com

How can we calibrate the level interface for Fisher® FIELDVUE® DLC3000?if use water to calibrate and our liquid SG are 0.75 and 1 ,Displacer height=14" and How much should be set SG in trasmitter during calibrate,for URV and LRV how shold be set

1 Answers  

---

(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.

0 Answers   ADMA OPCO,

---

what are the diff. in servo and regulatory control?

0 Answers  

---

What is force balance principle?

0 Answers  

---

if found error in magnetic flow meter?how can we adjust?

2 Answers   ANI Instruments, Techint,

---

What is Square Root Extractor for?

9 Answers   Sabic,

---

Explain the mechanism behind the turbine meter.

0 Answers  

---

Describe the typical instrumentation used in monitoring the performance of a shell and tube heat exchanger.

0 Answers  

---

when the operation engineer told you that he gives the control valve order to open but there is no response ! what will you do ? and if you found that there is astuck , what will you do ? (note : it is apanumatic valve )

5 Answers  

---

What is mean by SMART in an Instrumentation. is any full form for SMART?

3 Answers  

---

Why Current(Ampere) is chosen as Fundamental Quanties not Charge(coulomb) ?

3 Answers  

---

please suggest me, how can i change the display setting in term of unit in place of % of Honeywell pressure transmitter ST3000S100?

2 Answers  

---