Answer Posted / greenborhan
We generally use gas and diesel as burner's fuel in Bangladesh.
Some of our burners are designed for gas, some are for gas but most of our burners are designed for both gas and diesel i.e. we can use both gas and diesel as burner's fuel.
grenborhan@gmail.com
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
what is KV and XV valve
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
What are the types of valves?
in differential pressure transmitter,min&max pressure range for hp&lp
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
Explain the combusion chamber
How does your previous experience relate to the job you are applying for ?
Explain the use of hair spring in the pressure gauge.
What is offset in a control system.
Can anybody tell me how to select the size of earthing cable for DCS & PLC system.Please tell me any relevant answer here or mail it to me.
what is The specifications for oriface instalation
NSV type probe stands for
How is flow measured in square root?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
