Answer Posted / sachinbaindal48
BOILER IS ALSO KNOWN AS STEAM GENERATOR.IN WHICH THE HEAT IS
PRODUCED WATER IS CONVERTED INTO STREAM.THERE ARE COALS IS
USED AS FUEL.THEN THESE STEAM SEND TO THE GENERATOR AND
GENERATOR IS A DEVICE WHICH CONVERTS MECHANICAL ENERGY INTO
ELECTRICAL ENERGY.
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
With N nodes and B branches what will have a network ???
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
HOW TO CALCULATE ACCURACY OF AN INSTRUMENT. WHICH IS COMPITABLE FOR USE.
What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?
What is the working principle of the magnetic meter?
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
What is the difference bitween control net scaner and device net scaner
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
What is the start up procedure of desalter
What are different types of control valves?
can u briefly explain aboutan aryton shunt multirange DC ammeter?
why we use the ac supply load cell>?can we use the dc supply load cell?advantages and disadvantage of the ac supply load cell?
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
how pressure transmitter work, what is its principal to measure and how its generate signal. for pressure transmitterinstallation which precautions must be taken ??
where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve
