Answer / Pushpit Kumar

Isometric drawings are usually generated during the design or conceptualization phase of a project.

What is 3 selection available when configure the burnout protection for controller

1 Answers   EI Electrotechnical Institute,

---

principle of rtd

4 Answers  

---

how ranges is decided for drum level or dearator level,in my pplant i have seen for boiler drum range is -1000 to 1000mmwc, while for dearator -2000 to 0 mmwc ,why they decided to take this range ?

2 Answers  

---

which flow meter is use for measuring the open channel flow?

2 Answers  

---

why we use 250 ohms across HART CALIBRATOR DURING CALIBRATION OF TRANSMITTER

4 Answers  

---

If the on Of the DO module is off in the System cabinet, then what is the Procedure to check weather the Module is working or not.

2 Answers   Honeywell,

---

what is the meaing of calibration curve?

3 Answers   HCL, Honeywell,

---

What are the questions asked in fresher instrumentation candidates

0 Answers   Polmon,

---

What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?

1 Answers   KNPC,

---

What is the difference between sdv and bdv ?

1 Answers  

---

EXPLAIN NETWORK COMMUNICATION ON DCS?

0 Answers  

---

In most instances, Inertia processes are quite uncommon. Give an example of a combined Resistance and Capacitance situation.Describe an application, which according to your understanding of the subject matter, comprises of both Resistance and Capacitance effects.

1 Answers  

---