Answer / rajagopal

1.If there is no hp/lp bypass when the turbine is tripped and still boiler will be in service all the generated steam has to to evacuated by opening SH/RH vents.In presence of bypass system even when turbine is tripped we can possible to bypass the steam and dump it into condenser.
2.the major advantage of doing the above is we can maintain the boiler in hot condition with minimum steam generation cold start up and preservation after shutdown is quite difficult.

Answer / dwaragesh

To Mr. Rajagopal's answer also another advantage is DM water
is not wasted since it is collected in the condensor

Answer / dileep

To achieve rolling parameters we are using HP/LP Bypass system and in case of turbine tripped we evacuate residual steam.

Answer / m saqib rana

 waste heat energy sure

Answer / tarun sharma

in case any failure in hp and ip the steam need to bypass other wise the remval of steam from hp and lp is not possible

What is creep, resilience.

2 Answers  

---

What is A.T.T.?

4 Answers  

---

What is wheel chamber in steam turbine?is it impulse blades are called wheel chamber in the steam turbine?

1 Answers  

---

what is the meaning of SST300 V56A in SIEMENS turbine

1 Answers   Siemens,

---

2. what is meant by exhausthood temp?

4 Answers   Alstom, ANG, GMR,

---

why drum level falls when one of the running coal elevations tripped?

3 Answers   APGenco,

---

Why high pressure turbines are single flow 

3 Answers  

---

why IBD Vent is kept at higher elevation than CBD ?

5 Answers  

---

By any way can we increase the B check hours from 300 to 500

0 Answers  

---

What is Droop Control in Woodward?

3 Answers  

---

In a coal fired boiler furnace temp. is high but super heater out let temp. low what reason for this?

6 Answers   ABB, Essar, Gayatri,

---

why we use reduction gear box to reduce turbine high rpm to 1500 rpm in small plant

3 Answers   Maruti Suzuki, Sail,

---