Answer / kanawar

If generator having 4 pole then speed will be 1500 rpm for
50 Hz.rpm=120f/p

Answer / k.p.selvakumar.

We design the turbine rpm more than 1500 rpm ,like 5136,or 7700.because,our generator have 1500,rpm .our turbine designed having number of stages.it use for create the torque which we want.
Infact we using 1500 rpm of turbine, it cannot to able to create the desirable torque. So we using reduction gear 1500 rpm.,for high rpm turbine.

Answer / keyur donga

As we know our design of the turbine is more than 1500 rpn ,like 6500,7000.and generator designed at 1500
rpm,
when we use the turbine Which is rotate 1500 RPM Which is not able to create the torque,
So we use the reduction gear ,Which is rotate the at 1500 rpm
& Able to create the torque.

under which situation or why restricted earth fault protection operates in out side its zone that is external fault

2 Answers  

---

which safety valve will open first if steam is not been supplied to turbine.

3 Answers   Wartsila,

---

why is the in steam turbine axial displacement of active side thrust pad is positive and non active side thrust pad is negative.

0 Answers  

---

what is the formula for converting mmwc to tph in a dp type transmitter.what is the range in plc(in tph) if dp tx.range from 0 to 5000mmwc.

2 Answers   CCC, Korba Power Plant, Shyam Steel, Utkal Alumina International,

---

Power plants are called CPP,IPP,LLP What is the meaning of it? And tell me some other type of powerplant names.

1 Answers  

---

Why high pressure turbines are single flow 

3 Answers  

---

why IBD Vent is kept at higher elevation than CBD ?

5 Answers  

---

In a coal fired boiler furnace temp. is high but super heater out let temp. low what reason for this?

6 Answers   ABB, Essar, Gayatri,

---

what is water consumption rate of water to condense one ton steam in condensor.

1 Answers  

---

why high pressure heater will take after sufficient pressure? what happen when high pressure heater will take from COLD REHEAT line at light up time when hp and lp by pass in service.(means can we heater take at low pressure?)

2 Answers  

---

What should be the neutral and body grounding sysytem for grid (132 KV) parallel generators (440 volts)?

1 Answers   Rahimafrooz,

---

What is A.T.T.?

4 Answers  

---