Follow Our FB Page << CircleMedia.in >> for Daily Laughter. We Post Funny, Viral, Comedy Videos, Memes, Vines...


2. what is meant by exhausthood temp?

Answers were Sorted based on User's Feedback



2. what is meant by exhausthood temp?..

Answer / saurabh

the temp of the steam after passing from LP turbine.

Is This Answer Correct ?    17 Yes 0 No

2. what is meant by exhausthood temp?..

Answer / sheik nasir hussen

The temp of the steam after passing lp zone&where steam is exhaust(temp in the area of steam exhaust).

Is This Answer Correct ?    0 Yes 0 No

2. what is meant by exhausthood temp?..

Answer / ritesh patel

LOW PRESSURE TURBINE EXHAUST PRESSURE

Is This Answer Correct ?    4 Yes 7 No

2. what is meant by exhausthood temp?..

Answer / pappu singh

It is condensate steam which comes from lp side.

Is This Answer Correct ?    0 Yes 5 No

Post New Answer

More Power Plant Engineering Interview Questions

Which will have more strain energy 1.Spring 2.Circular disc 3.Solid square plate.

0 Answers  


In one plant id fan and fd fan are used for boiler. boiler is used to heat water after some days they install one tank to heat water by hot flue gases coming out from boiler and then hot flue gases are used to heat the air coming from fd fan before leaving out from chimney . but hot flue gases are not coming out from id fan what might be the reason?

3 Answers   TATA,


why prds line tapping taken from ms line as Pri SH O/L temp & pressure is sufficient to full fill our requirement of PRDS..

3 Answers   GIPCL, OEGI,


what is turn down ratio

4 Answers  


I am opertaing generators which are beyond 14000hrs and now the fuel consumption is about 2kw per liter of diesel. The engines are due for overhauling. is this normal

1 Answers  






why the Steam Turbine(20MW)center line and gear box center line not in same elevation during coupling alignment ?

3 Answers   Greenesol Power Systems,


What happens if air is present in LPH and HPH.

2 Answers  


1. what is meant by burner tilting?

3 Answers  


what is significance of canister vent in condensate extraction pump & difference between vacuume balancinf line & canister vent

3 Answers   NTPC, Tata Power,


What is LB-SR.

0 Answers  


how to differentiate between "ALL fuel lost" and "All Flame Lost" in Boiler MFT condition?

1 Answers  


im try to calculating seawater flow required for SW-FGD system. I need a guide, equation or method to do it, can some one help me! Thanks very much

0 Answers   Student,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5081)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4448)
  • Electrical Engineering Interview Questions Electrical Engineering (16623)
  • Electronics Communications Interview Questions Electronics Communications (3915)
  • Chemical Engineering Interview Questions Chemical Engineering (1093)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (214)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3008)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (171)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (0)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)