Answer / ramakrishna karri

ratio between average load to peak load in a specified time period. high Load factor means plant running consistently is good.

Answer / gajanan kuhite

PLF is nothing but the plant load factor & it is calculated
by following formula

%PLF = avg.load/total installed capacity *100

Answer / asddf

Total generation / plant capacity×24

Answer / s m mishra

PLF of power plant is efficiency of the palnt

Answer / ppic

visit- www.powerplantinstrumentationcontrol.yolasite.com

Answer / prashanth

PLF=GENRATION*1000/GENRATOR FULL LOAD*24=PLF

how many safeties should be present in boiler?what are they?

4 Answers   DN, Nandi, Pump Technology, Siris, Thermax,

What is the over speed in turbine? What is critical speed?

3 Answers  

Why attemperation is required in HRSG in a combined cycle power plant?

10 Answers   Tata Power,

What happens if lizard comes in a MOCB

1 Answers   ABB, Reliance,

What is droop.

2 Answers   Dhampur Sugar Mills, Elaf,

how shall you calculate PLF on the basis of percentage auxillary load factor

6 Answers  

what is significance of canister vent in condensate extraction pump & difference between vacuume balancinf line & canister vent

3 Answers   NTPC, Tata Power,

What will happen if the Air Preheater is placed before the Economiser?

6 Answers   Bhel, KSPL, Tata Power,

What happens if there is no HP and LP By-pass.

5 Answers  

why we use reduction gear box to reduce turbine high rpm to 1500 rpm in small plant

3 Answers   Maruti Suzuki, Sail,

In one plant id fan and fd fan are used for boiler. boiler is used to heat water after some days they install one tank to heat water by hot flue gases coming out from boiler and then hot flue gases are used to heat the air coming from fd fan before leaving out from chimney . but hot flue gases are not coming out from id fan what might be the reason?

3 Answers   TATA,

What happens if air is present in LPH and HPH.

2 Answers