what is use of stater and choke in tube light.?

Question Posted / dharmans.333

2 Answers
5487 Views
Aditya Birla, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what is use of stater and choke in tube light.?..

Answer / vilas

Choke is used for to reduce the low frequency signals that means it bloks that signal

Is This Answer Correct ?

0 Yes

0 No

what is use of stater and choke in tube light.?..

Answer / jaya senthil nathan

choke is used to step up the voltage
starter is to seperate the initial voltage into two for two
ends of the tube light ,....

Is This Answer Correct ?

3 Yes

6 No

Post New Answer

More Electrical Engineering Interview Questions

why distribution transformer is uesd in Delta/Star formation?is there any significance in doing this?If yes then breif?

3 Answers

suppose MCC (Motor control center)panel work on field the relay on this damage or not work and earth fault occurs in this and no indication in relay panel given below. than MCB trip or not and what effect the panel how find relay will damage or not work.

2 Answers

When PRV operated at power transformer ,can anybody tell me particular pressure for 50mva transformer plzzz.

1 Answers BWSSB,

What is surger vector in 33Kv transmission feeder? We have AC power generator of 8MW which is paralleled with 33Kv EB grid. Some times our HT breaker gets trip off due to surge vector problem. How to over come it? Is there any device to observe the surge and avoid tripping?

3 Answers

what is the minning of propotional, integral, derivative ?

1 Answers

How will polarity test of Dy5 Transformer ?

0 Answers

in power generator normaly voltagr betwween esth to neutral is 0 but my work place generator show the volatge is 60v any body know why? thanks

0 Answers

Merz-Price circulating current principles is more suitable for

1 Answers Student,

at work i have a genertor/alternater what is the easyest way to work out if it is dc or ac?

0 Answers

im working in one private compeny in gujarat. i was complet diploma electric in 2010 from gujarat technical board. now i want electric supervisor licence in gujarat but i dont't know when i apply? plz give me address of the licence dippartment office in gujarat. gandhinagar

0 Answers

If any cable burnt how can we identify it burnt by high current of high voltage?

0 Answers

what is the difference between direct loading and indirect loading?

1 Answers

For more Electrical Engineering Interview Questions Click Here