Why we are designed only 11Kv and 6.6Kv Alternators, not 33Kv Alternators and

Why we are designed only 11Kv and 6.6Kv Alternators, not
33Kv Alternators and Power Transmission side we are
designed only 220kv, 120kv, 66kv, 33kv, 11kv, and 440volts,
not 20kv, 50kv, 100kv.

Question Posted / vpchsekhar

2 Answers
8019 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Why we are designed only 11Kv and 6.6Kv Alternators, not 33Kv Alternators and Power Transmission s..

Answer / k.prakashchandra

Insulation vs KV and current vs KV

Is This Answer Correct ?

4 Yes

2 No

Why we are designed only 11Kv and 6.6Kv Alternators, not 33Kv Alternators and Power Transmission s..

Answer / jignesh

b'cas of the foam factor is 1.1

Is This Answer Correct ?

0 Yes

2 No

Post New Answer

More Electrical Engineering Interview Questions

what is the iron loss in a 11KV/440V transformer?

2 Answers Bhel, TVS,

why t/f are rated in kva. is it conserned with p.f.

3 Answers

Explain the working principle of Synchronous Generator and Assynchronous generator?

0 Answers

what is a bus post insulator? explain its application in a substation.

1 Answers Enercon, HAL,

how to define vector group of transformer

1 Answers Engro, Reliance, TATA,

what are the materials used in HRC fuse

3 Answers Bhel,

which is more dangerous A.c or D.C?

26 Answers

Why do we use copper cable for HT Supply and why not Aluminium?

0 Answers

If OLTC is in manual position there is chance to variation of voltage(Low or High)?

1 Answers Juniper Networks,

what is the meaning of bus bar, in electrical panels.

13 Answers HLG Habtoor Leighton Group,

If u take a kWh reading in 11 kV HT and 440 LV side at same time in yesterday today , then why LT consumed units 3-4℅ high as compared to HT units

1 Answers Brigade,

why there is a phase shift lies between primary and secondary voltages of a transformer?

7 Answers Mecon,

For more Electrical Engineering Interview Questions Click Here