what is the necessity of under ground cables ??
No Answer is Posted For this Question
Be the First to Post Answer
Three set (each phase contain 2 cable of 400 mmsq CU XLPE AWA) of single core cables are connected to 11 KV motor of 14 MW & the switch gear supplay is taken from 11kv feeder & this supplay taken from 275 KV substation. Problem is one pair cable(L3- 2 cable ) getting very hot & gland melted and damaged in switch gear side. the other two cable haven't any more hot(ambient temp only & L3 haveing 95- 100 Degree C. The same problem happened in 275 KV substation switch gear side also where the supply taken for 11 kv switch gear. But here L2 phese cable had problem. Why it is happening like this?. The cable having temperature different at different location from gland side inthe case of 11KV feeder of 275 kv substation. why ?
which type of motor using in drilling machine ? & who to produce very high torque in drilling machine?
1 Answers National Drilling Company,
what is meant by fuzzy logic? what is fuzzification and defuzzification?
What is LOP Sensor in DG??????
what is the difference between RTD & TERMO COUPLE?
What is the result of under frequency to the system.
What it indicates by 25/41MVA on transformer?
why ac signals are sinosuidal
what is impedence in transformer
What is a feedback in control system?
why usa use 60hz and 110v?
Why LT cables are not sized based on short circuit capacity.