Answer / Bhawana Kemokharia

The sensitivity of a current transformer (CT) depends on its core material, winding design, and the applied excitation. To increase the sensitivity, you can consider using a low-reluctance core material like amorphous metal or powdered iron, optimizing the winding layout for minimum leakage flux, and reducing the tap setting.

can we run a motor rated 50Hz,415vac,1440RPM At higher speed then rated on name plate with the help of VFD /drive on long term basis.wheater it will effect the motor life

3 Answers  

---

what are the components in electrical control panel (for example: 415V, 3-ph, panel to operate utility and 3-ph DG set).

1 Answers  

---

what is "PE" earthing? and what do u know abt 16mm cable?

1 Answers  

---

why we used ZNO in Lightning arrester.

1 Answers  

---

Is the installation of the filter cloths necessary before spreading the gravels at the transformer yards?

1 Answers  

---

how can we select the rating of Load break switch that is connected to the primary protection of 200 kva 11kv/415v distribution transformer?? step by step calculated answr pls...thnk.u

2 Answers   Maruti Suzuki,

---

sir, Two different rating of generator going to connect parallel, can it set same DROOP or different. Why? Please explain

2 Answers   Kirloskar,

---

What is current and voltage?

5 Answers  

---

what is the function of switch gear ?

10 Answers   Exxaro,

---

What is the GI Earth Flat Size recomended for 33KV 2000KVA Distribution Transformer

1 Answers  

---

What will happen if i used 11KV earth ht kit to 11 KV / 11 KV cable termination?

1 Answers  

---

How we can calc. the Backup time of a battery Bank???

6 Answers   Emerson,

---