Interested to Buy Any Domain ? << Click Here >> for more details...
what is use of stater and choke in tube light.?
- 2 Answers
- 5717 Views
- Aditya Birla, I also Faced
- E-Mail Answers
Answer Posted / jaya senthil nathan
choke is used to step up the voltage
starter is to seperate the initial voltage into two for two
ends of the tube light ,....
| Is This Answer Correct ? | 3 Yes | 6 No |
Post New Answer View All Answers
could anybody able 2 send me jindal steels previous papers fr electrical steam....pls send 2 my id if possible....sirisha.shaik@gmail.com
WHATIS TIME CONSTANT? WHATIS ITS SIGNIFICANCE? ILLUSTRATE THROUGH EXAMLES.
Why the output of OP-AMP is always less than Vcc?
how generator avr give to the input?
What is trip and closing coil in cb? Why need of them
What is the tests required for a 132 kV, 400 kV , 765 kV for a Circuit Breaker and Power Transformer before commissioning ?
Practical condition in 400KV Sub station:- Breaker(open) , isolator(open), Earthing (close) at both end e.g A & B. Now Open A Stn Earthing than Open B stn Earthing (Which have a 50MVA reactor) , AND suddenly show R,Y,B phase 704KV,573KV,118KV respectively. Que is without closing of breaker how it is possible.???? My Whats app No:07621840498 for Further Discussion. Pls experts suggest.
How o select the electrical fuse?.What are its characteristics.How to select the material od fuse?
whether starting current is limited to rated current of motor through soft starting or it exceeds the rated current?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
why is control bus bi-directional?
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
What are the application of filter?
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details
