what is the difference between earthed cables and unearthed
cables
Answers were Sorted based on User's Feedback
Answer / balakrishnan.t
to avoid any induced emf in the inner cable by lighting or through other means the outer shield or armouring is ussually earthed this is called earthed cable and cable without this is called unearthed cable.
Is This Answer Correct ? | 3 Yes | 0 No |
Answer / kiran
Safty of the Equipment.which is the connected Earth Cable
power is not passed the Equipment.
Is This Answer Correct ? | 0 Yes | 3 No |
what is the size(sq.mm) of these conductors dog,rabbit,tiger,panther,mush,
What happens if fuse is connected to neutral wire
What is maximum permissible length of cable from transformer (33kV/0.433kV) HT side to HT panel which contain VCB? In which standard i shall get this information.
On load tap changer (OLTC) explode? Transformer Vector group: Ynd11 Rated Power: 353MVA Rated Current: 693A Voltage:294/20KV OLTC Type: T III Y1000 110/c 12193w Max Operation Current: 295A Step Voltage: 550V Arrangement in Tx windings: Y Connection Problem: Damage of Unit 1 Generator Transformer On Load Tap Changer (OLTC) Description of Incident: 9.00 a.m. :- Generator No Load test on excitation system started 10.30 a.m :- Carried out AVR change over test 11.30 a.m :- Preparation for Generator Manual Synchronizing test 12.00 a.m :- Manual Synshronizing test started. Observed incoming generator voltage higher than running voltage. CECR operator operated Generator Transformer OLTC to bring down the incoming generator voltage 12.03 a.m :-Generator Transformer abnormal alarm operated at Gen.Control Desk (CECR) CECR operater at Generator transformer bay informed that the transformer oil splashed out from OLTC. CECR operater informed that he heard explosion inside OLTC. Observed Oil level & Oil Flow alaram operated at Tranformer local annunciator. 12.05 am :- CECR operator 'Open Gen Field Breaker” 12.10 a.m. :- Elec1 team inspected the OLTC and found the OLTC rupture disk was broken and oil spilled at OLTC area. - Elec1 found the OLTC top cover bulging. Do anyone know why and possibility cause happen in this OLTC.
what is the contact resistance of Air circuit breaker??
whenever any squirrel or a crow falls on the transformer input line then there is a big explosion and 440 volts of power is being discharged through the neutral line due to which appliances in off mode are also burned.we have earthing for the transformer as well as the bus bar chamber.why is it happening?
What is the need of motor starter?
Why did call copper as a electrical conductor?
How energy is generated in hydroelectric power plant?
What is the Load Capacity of Panther conductor (0.2) and dog conductor (0.1)
What is order of the system?
what is tpdt