Answer / k.prakashchandra

Horn gap fuse is fixed between two rods bent to form the
shape of a horn facing upwards.It is also called as HG fuse
in short.It is used on 11 KV side of DTC (dist tr center)for
protection against overload for each phase.

What is the minimum distance between MV busbare (P to P & P to E) as per some standards

1 Answers   ABB, Sejong,

---

how to convert lv line to hv line and viseversa, any losses will occur during this process

0 Answers   Jindal,

---

why we decide alternating wave form in ac system and not in dc system

2 Answers   GMR,

---

What is cp system and why is it required.?

1 Answers   Essar,

---

Why is remote backup preferred to local backup?

0 Answers  

---

why SCR use in power plant

1 Answers   Edison,

---

How much KVAr bank reqired for 630 KVA transformer on full load for maintain power factor upto.99

4 Answers   Dhanalakshmi Industries, DLF,

---

what will happen if frequency is below 50 hz?

0 Answers   Student,

---

In three phase, phase to phase voltage is 440 Volts, but the three phase motors are designed for 415 Volt, 50 hz, why

1 Answers   Shree Ram, Shriram, Sri Ram,

---

Refernce currents are to be generated using refernce cueernts how can this be done

0 Answers   ABC, Wipro,

---

why the transformer secondary voltage is more than the load end voltage like t/f 11KV/433V for 415V(terminal voltage)

4 Answers  

---

what is the working principle of ceiling fan and table fan?

10 Answers   ABC, Tata Steel Limited,

---