why we decide alternating wave form in ac system and not in dc system

why we decide alternating wave form in ac system and not in
dc system

Question Posted / manikanta

2 Answers
4628 Views
GMR, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

why we decide alternating wave form in ac system and not in dc system ..

Answer / mubeen

DC system is expensive and have less quantity of voltage
than Ac system.Ac system consuming less power than DC
system.AC power can be easily reduce or increase (step up /
step down ) by the transformers.But for DC required so many
equipment to increase the voltage flow.

Is This Answer Correct ?

3 Yes

4 No

why we decide alternating wave form in ac system and not in dc system ..

Answer / prem

that may not right, initially any where or any place the induced voltages are AC only, in order to analyse the things
we show by AC

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

what will happen reduce the transformer voltage from 415v to 406v, is it save the energy,? are this methodis good to reduce the energy.?

0 Answers

WHICH TYPE OF TRANSFORMER IS USED IN POWER TRANSMISSION BASED ON TRANSFORMER CONNECTION ON PRIMARY AND SECONDARY SIDE

3 Answers

what is meant by dielectirc medium? what is the dielectirc value of air and water???

2 Answers ISRO,

what is the ranje of HT cabel and LT Cabel.

1 Answers Sail,

How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?

0 Answers

What happens when generator is running with leading power factor on it say -0.96. what are the effects of it on alternator and the other generators operating in parallel to it.

2 Answers

what is the EMF

2 Answers

sir , what happen if we decrease ( approx 3 inch ) the lenth of shaft in 110KW Induction , three phase motor. actually a 110KW motor is couppled with star couplling to 120TR compressor. When we doing maintenance in compressor it is required to skid the motor backword and resulting dis- alightnment . so we want to change the tyre coupling in place of existing coupling. so it is required to cut off the rotor aprox 3 inch form driving side.

2 Answers

we have total 1000hp motors we paid 7 laks rupees how to reduce power bill

4 Answers

What is PIR (pre inserting resistance) in 400kv EHV SF6 BREAKER? Why it use?

1 Answers Adani,

why do we prefer -48 volt instead of -24volt or -12 volt etc. ??

1 Answers

what are the reasons for overheating in electrical machines?

3 Answers

For more Electrical Engineering Interview Questions Click Here