Refernce currents are to be generated using refernce
cueernts how can this be done
No Answer is Posted For this Question
Be the First to Post Answer
What is the transformenr turns ratio.
is it possible to step down voltage of single phase from a three phase sysem? explain
I have a 33 KV sub stn with two mother transformers 33/11 KV of capacity 3150 and 1600 KVA respectively. The total connected load 16809 KVA(11/0.433KV).how i calculate the max current & how i decided the CMD.
how can we rotate a single phase motor (without cap.)in reverse direction?
How would we calculate the no of earthing pits required for motor /panel
5 Answers APGenco, National Engineering Industries, Practical Viva Questions,
why generation of electricity in low value voltage
ON WHAT BASIS LOADS ARE CLASSIFIED AS RESISTIVE,INDUCTIVE AND CAPACITIVE LOADS?.GIVE PRACTICAL EXAMPLES FOR EACH
1 HT service how many LT Service
What is the purpose of SOTF being used inspite of distance Protection given?
Give details of your interested designation, the post you are interested to serve the company better and explain why you think you can serve the company better in such position if employed?
how can we run the induction motor at 9000 rpm ,by keeping frequency constant??
Why not implimenting power factor in Diesel generator
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)