Answer / rmatsaat

If you are referring to cathodic protection, here is my simplified answer..

Cp is needed to protect metal from surface corrosion. By using sacrificial anode you are ensuring the protected metal does not corrode until all the anode used up (exhaused. From corrosion)

If you use impressed current cp (iccp), you are 'reversing' the natural process of metal reduction (-hence corrode), protecting the metal from corroding.

what is the calculation of current when a clampmeter is attached to two phases of any drives.

3 Answers   ABB,

---

How to calculate the rating of ELCB OR RCCB for an equipment?

2 Answers  

---

What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?

0 Answers  

---

What is the fusing factor ?

4 Answers   MESCOM Mangalore Electricity Supply Company Limited,

---

In cable sizing calculation (determining the max route length of cable) why we choose the shortest length between cable length of full load current Iflc & starting current Istart?

0 Answers  

---

can we run all LT motors at 360 volts which are normally rated 415+/-10% voltage rating

2 Answers   Meinhardt,

---

How to decide DO set rating of Transformer?

0 Answers  

---

can we use 400w coke instead of 250w choke in 250w fittings

2 Answers  

---

what is the reasons for blowing fuse

1 Answers  

---

what is the MNA in case of d.c. machin? whaty is the importance of it? hoe it affect the brush position?

2 Answers   TATA,

---

operation of diesel generator

0 Answers  

---

what is XLPE cable?

2 Answers   Essar,

---