Answer / harathi nitin

As per Joglaker (Quantity Surveyor Book) it is mentioned as
for every quintal of steel reinforcement ( 1 quintal =
100kg) 0.9 to 1.3kg of binding wire is required

for 100kg of steel reinforcement = 0.9 to 1.3kg of binding
wire

for 1 tonne (1000kg) = 9 to 13kg binding wire will be
required

Answer / a.ramachandran

approximate 8kg, it is based upon thumb rule.

Answer / pradipkrdeb

It should be 5 Kg to 6 Kg for one tone reinforcement.

Answer / siva

Upto 16mm dia = 6.90/7.20kgs
20mm to 32mm = 8.00/8.30kgs

Answer / t.chandrasekar

10 kg of binding wire is normally required for tying 1tonne
of reinforcement rods

Answer / srinu.s

Genearly used for binding wire for 1tone
up to 8mm to 10 mm steel = 5kg/tone

12 mm to 16 mm steel= 6.5 to 7.65 kg/tone

20mm to 32 mm steel= 8.2 to 9.85 kg/tone

Answer / jitendra

it depends on reinforcement work and gague of binding wire,
for overall calculation 12 kg consumed for Residential
building .steel binding wire

Answer / surendra pal singh

one tone reinforcement required binding wire 10kg to 13kg
Note- depend on rcc strecture residential & commercial.

Answer / karthik

8kg required for 1ton

Answer / guest

10kg

how much shuttering oil required for 100 sqm shuttering?

1 Answers   L&T, NCC,

what is difference between active and passive earth pressure. how it effect the retaining wall design ?

4 Answers  

1) what is the use of pin and plate vibrators during slab casting? 2) how much cement bags are required for 1sqm 4inch brick wall? 3) Is it viable to provide overlap at column , beam & slab junction. if no why? 4) if bar dia is changing in column reinforcement , which dia bars overlap is considered? 5) what is isolated and ecentric footing?

4 Answers  

which is cover of r.c.c. column,beam and slab

5 Answers   Cube, RPP,

what is called the inverd level of mabhole chamber?

0 Answers   PBL,

Whr should a joint be located in a beam if the provision of a joint is unavoidable??

2 Answers   BMTC,

what is meant by geosyntahtic system

1 Answers   Bhel,

How many bricks will be fit in one cubic meter, if the brick measurement is 0.20cm X0.08, If you also write down the formula for this question too.

3 Answers   Vardhman,

What is the average density of soil?

0 Answers  

sir my site not availabele 12mm steel now if i use 10 mm how many spacing require for slab design slab thk 200mm footing, column,raft,wall how can calculate give me formula

2 Answers   Amrapali,

State the type of roads and compare the advantages and disadvantages?

1 Answers   Parsvnath,

what are the types of flow? what is terbulent flow?

3 Answers