Answer / bodhisatwa goswami

The lap should be considered with bar 20mm, i.e 40D = 40*20... and the length of the lap should be provided in the lesser dia 16mm.

Answer / gobinda paul

20 mm dia will be in consideration,because if we consider 16
mm, then 20 mm dia will not get its fully development
length.but in case of consideration 20 mm both the rod will
get there development fully.

what is high type road and low type roads

0 Answers  

---

Please tell me 1 Sqm Steel 14mm center to center .200,.200

2 Answers   Al Shalawi,

---

I need Bhel engineertrainy test papers in civil engineering please send to email id - hisandy66@gmail.com

0 Answers  

---

asubmerged weir is one in which the water level on the down stream side of the weir is just at the crest level below the crest level above the crest level at stamp elevation as water surface on upstream

0 Answers  

---

what is a weight of 10mm, 20mm, 40mm aggregate ?

1 Answers  

---

What are the specification of good quality sand for plaster and brickwork?

2 Answers  

---

calculation of quantities of cement and sand in 1cum mortar with 1:6 ratio

6 Answers   Hitech, MBA, Oasis,

---

225 mm thick RCC slab, how many ton load slab can carry? for example if 33 ton truck loaded with soil, truck having 6 wheels. slab can take load or not? grade of concrete is M35 and slab design Fe500, slab desing one way slab.

0 Answers  

---

what is mean of buld density

1 Answers   HPCL, NOW,

---

How much does it cost for a R.C.C roof slab of size (25 X 20) given in feets using 1:2:4 concrete mix of M20?

7 Answers  

---

What is the difference between built area and super built up area?

0 Answers  

---

wheather Micro silica/silica fumes is an ad-mixture or accelerator.

5 Answers   Coastal Projects,

---