what r the parts calibrated in gc
Answers were Sorted based on User's Feedback
Answer / s.ramanjaneyulu
The GC Calibration parameters are
a)FID(Flame Ionisation Detector) for Responce purpose
b)ECD Electron Capture Detector) for Responce purpose
c)Head-Space sampler
d)H2 Flow,N2 or He Flow (Carrier gas flow rate what u are
using)
Is This Answer Correct ? | 1 Yes | 1 No |
Answer / surya
1. Flow rate accuracy
2. Oven temperature
3. System precision
4. Injector linearity
5. detector linearity
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / venkatanarayana
Leak test,System Precision , Detector Linearity
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / venkat
system sutabulity
detecter linearty
auto injecter vial position check
injection volume
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / viswanathan
1)Detector flow and column flow
2)Column oven temp minimum and maximum (based on operating range)
3)Detector linearity
4)injector precision and linearity
5)HS vial detection test
6)Noise and drift
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / umamahesh
carrier gas flow check,detector linearity,injection precision by auto sampler and injection precision of head space
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / gangaram kolekar
1.Linearity of detector response ( FID )
2.Temperature Calibration ( Column Oven )
3.Flow rate Accuracy
4.Correlation coefficient
5.Precession
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / gaurav
Auto injector, detectors, most important: Column
Is This Answer Correct ? | 1 Yes | 2 No |
how calculate column dead volume in hplc ?
If we have 120 minutes run time method for HPLC and you wan to decrease the Run time so what should you do??
How can we confirm the HPLC column is end-capped or not? Is it possible to identify by physical appearance?
what is the meaning of PURITY AND POTENCY .what is the difference between PURITY and POTENCY
What is normality
which effect is mainly responsible for chromatographic separation when silica is the statinary phase at TLC? thanks in advance
In C8,C18....etc have 4&5 etc... microns Columns is there like that how to separate Chiral columns as per Micron size?
how to calculate elemental impurities?
Difference between standard operating procedure and standard test procedures in pharmaceutical industry
What is the principle of HPLC, GC, LCMS, GCMS,LC QQQ, GC QQQ, LC Q TOF and GC Q TOF. What are the applications and Specificity?
In BP2013, Loperamid HCl monograph. Assay by titration with 0.1N sodium hydroxide using hydrocloric acid 0.01N and reading the volume added between the 2 points of inflexion. I have a question that if the diluent solvent is ethanol is certainly consumed a amount of volume of titrant, so this volume must be eliminated on the result calculation or not apart from first point which is subtracted above.
What is colimn selection Criteria in HPLC analysis?