TELL ME, WHERE SHALL I GET BASIC ELECTRICAL ENGINEERING BOOKS IN INTERNET?IT SHOULD CONTAIN ALL DEFINITIONS?
TCS,
2322HI SIR, AM PREPARING FOR RRB FOR SECTION ENGINEER POST. PLZ SEND ME THE PREVIOUS QUESTION PAPERS AND HELP ME. I HAVE NO ENOUGH TIME MY EXAM DATE IS 22ND JUNE.... MY EMAIL ID IS nalla.amarnath@gmail.com
1933Slow acting fuses are most often used for which application a) Lighting circuit b) heating circuit c) Motor D) Radar circuit
1 3860What are the consequences in using existing step up transformer (primary 6.6kv/175A, secondary 480v/2405A) for step down transformer to have a 6.6kv output?
1 3570what is neutral grounding? why is it required? what is neutral grounding resistor and how is its value calculated??
11 65753WHAT IS BASICS TO SELECTION OF 11 kv Trasformer, send any calculation sheet for selection of transformer
NBCC,
3 10598Post New Electrical Engineering Questions
1.why we are using metal oxide gapless block in lightning arrester,2.What is minimum and maximum rating of metal oxide blocks using in india
What is Antipumping Function & If we have C.T how we find the Ratio ?
Explain the method to keep noises low in a control system?
Apparent power is expressed as V * I(Conjugate). Why not in V * I ?
what are the differant std sizes of cable trenches?
oil cooled transformer
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
Why do we avoid electrical conduits in floors at apartments?
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
Which type of questions well asked. ?
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?
how to calculate regulation constants for over head lines? and what are the regulation constant for raccoon conductor at different voltage level and different P.F?
how to flameproof electrical motor on the shaft?
how to calculate the size of the HT cable