Does frequency change with increasing voltage i.e 220v to
11kv? explain if not?
Answers were Sorted based on User's Feedback
Answer / sachin_pawaskar2001
Steping Up or Down the voltage depends on the ratio of no.
of turns on Transformer primary & secondary winding. Bothe
the times frequency remains same.
Is This Answer Correct ? | 25 Yes | 0 No |
Frequency: No. of Cycles per Second (1/T). So Frequency
will depend on Time Period Not in Magnetude. If magnetude
of Voltage increases(220V to 11KV) threre is no effect on
Frequency
Is This Answer Correct ? | 21 Yes | 1 No |
Answer / sirisha
the frequency of the supply remains same irrespective of
the the voltage changes.
Is This Answer Correct ? | 12 Yes | 0 No |
Answer / amit kumar sharma
Speed of any machine = 120* F / P
F = frequency
P = No of poles
F=(speed x P)/ 120
Frequency is not related on any factor of generation, hence
could not be changed due to variation in Voltage.
Is This Answer Correct ? | 11 Yes | 1 No |
Answer / jay
transformer is a static device which transfers energy by stepping up or stepping down voltage with constant frequency.
Is This Answer Correct ? | 4 Yes | 0 No |
30 kva ups may kitne output voltage hote h
what is the use nuetral wire
power formula
Why don't we use ground free electricity to avoid electric shock.As birds are do not get shock.
Can anybody tell me why inductors draw lagging current and capacitors draw leading current from supply?
what is the dedicated earthing
why back up fuse used in vacuum magnetic contactor?
I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air con compressor is running at that time rectifier voltages are increasing upto 290-295 v and rectifier is giving main high alarm (rectifier is APC single phase, before starting compressor rectifier voltages was 230v. when air con is going off rectifier voltages are decreasing smoothly at its actual voltages 230v. Load on Genset phases is this: Red-13.5 amp AC (Air Con load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp AC (telecom system load), Genset phase to phase and neutral to phase voltages are also ok. These are 10 sites having same system and same rectifier APC brand at every site 02 genset are working but the problem is same at all these 10 sites. What will be the reason behind???
types of transformers?
what is the main use of ac and dc drives ? it is only used for speed variation or for power saver also?
why power factor laggs and leads in case of inductance and capacitance??
what is the basic principle of TV camera?