What are the consequences in using existing step up
transformer (primary 6.6kv/175A, secondary 480v/2405A) for
step down transformer to have a 6.6kv output?



What are the consequences in using existing step up transformer (primary 6.6kv/175A, secondary 480..

Answer / blake australia

The only real limitations on a transformer are overvoltage
and heating. Using the transformer to step up instead of
step down will make no difference. However, the protection
relay settings for this transformer, and some other parts
of the network, will need to be changed.

Is This Answer Correct ?    3 Yes 1 No

Post New Answer

More Electrical Engineering Interview Questions

it says in neutral wire current flows under normal condition, but when we put tester it wont glow, why?

7 Answers   HCL,


what is the difference between electrical & electronics

245 Answers   Axon Constructions, Banking, GDA Technologies, Infosys, MBA, Satyam, Satyam Tech, Snow White, TCS,


What is the purpose of Rotor earth fault relay and How to test the Rotor earth fault relay in generators and What is the procedure?.

1 Answers  


DEAR ALL I have motors ( 10 units )each one is 90kw 380V 50 HZ 1000rpm but new local pwer is 220v 60 hz requierd rpm should be 1000 pleas what the beast solution is used frequncy converter or rewinding all motos or chang all motors thanks

6 Answers   GE,


why bucholtz relay placed inclined in transformer?

1 Answers  






In DC current-excitation to transformer, why it sucks more current? Eventhough there is no power transfer between primary and secondary? R is very low so it should suck less current only na thn y its current increases?

2 Answers   Cairn,


what's the different between ELCB, ELR and ELS?

1 Answers   CP,


where is used dc volage transformer,and what is highest capacity of transformer

2 Answers  


what is power factor when in view of a lineman

3 Answers   KSEB,


1.stranded resistance values of motors? 2.how to calculate the resistance values of single phase and 3phase motors?

2 Answers   Bell, L&T,


what type of motor is used in washing machine

8 Answers  


what is the Excaste meaning of CT Saturation?? 10 P 20, 15 VA, what is the meaning of 10, & 20. if the CT polarrity changed what will happened?? what is the differece between measuring CT & Protection CT?? what is the Saturation Point of measuring CT & Protection CT??

1 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)