How we detect the leakage current of 11 KV H.T. motors and
waht is the maximim limit?
Answers were Sorted based on User's Feedback
Answer / jeetendra verma
leakage current causes due to detoration of insulation it
can be determine by partial discharge methord
| Is This Answer Correct ? | 13 Yes | 0 No |
Answer / prabhu gnanasekaran
There are two issuse excisting 1.Leakage current2.return
current. Return current is nothing but the it is a small
amout of current that flows in the neutral when the circuit
is not closed. These neutral current can be senced by RCD
(Recidual current devises). Wheareas the leakage current is
one when your cable is shorted or any open circuit to the
ground which can be senced by CORE BLANCE CURRENT
TRANSFORMERS. When there is no leakage current then the
current in all the 3 core will be same. If any leakage
current excits then the current will not be same.
| Is This Answer Correct ? | 11 Yes | 6 No |
EXPLAIN THE TRANSFORMER MAINTENANCE?
what is emitter follower configuration? and what are it's features?
What is the Working principle of ELCB and RCCB?
what is the technical diffrences of mccb and acb
I NEED RRB CHENNAI (JE ELECTRICAL) QUESTION PAPER FOR LAST 5 YEAR AND I NEED RRB (JE ELECTRICAL) SYLLABUS.PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in
12 Answers DFM, Hindustan Unilever Limited, JE, Pace, RRB,
Why 50hz and 60hz frequencies are used by the world, why they are not taking 55hz?
what happens in the short circuited secondary transformer,if the resistance of the short circuit is increased gradually?
Is a d.c.compound motor is use as a booster? how?
bit confused - am i correct in thinking that to determine line to line voltage in a star config 110v 3 phase 4 wire distribution system i would use a voltmeter? I have a circuit configured as an unbalanced load, consisting of three incandescent lamps (1x40w, 1x60w, 1x100w - all 110v rated)connected in a star configuration to a 110v 3 phase 4 wire distribution system. I want to find out what types of meters i would use to obtain: a) each line to line voltage b) the line to neutral voltage across each load c) current flowing in each line and load d) current flowing in the neutral conductor e) power supplied to the loads im assuming i would be using ammeters in series along each line and voltmeters in parallel across each line to neutral? Also how could i predict these meter readings before taking them and with which formulae? Any help would be greatly appreciated A.
why transfromer rating gives in MVA Or KVA? Why not in MW or KW?
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
What is the need of ISOLATION Transformer?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)