in 50 mw generator if field is open in full load running condition what happen and for protection which relay used?5 4497
if generator is running in iso mode parrallel with grid and suddenly grid breaker off what will happen?6 8943
boiler is running in rankine cycle and deisel generator is....?1095
what is the difference between isolation and insolation ? please explain in detail with example.
ARE YOU NOURVAS ?4 5284
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
What are RMU yard Safety Operating Procedures2 9204
My question is abt backlog.I had dropped one subject in my second year, and completed this subject in the 3rd attempt, so how many backlogs i have got?1 or 3?plz sujjest the answer as soon as possible1153
how to calculate maximum current
What is control system?
What is the voltage gain or transfer function of amplifier?
Don't you have similar question banks related to Oral Certification Examination conducted by Mercantile Marine Departments / Directorate of Shipping, Ministry of Shipping for Electro Technical Officer?
What is the effect on 3phase induction motor if current setting knob of DOL kept at minimum current?
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
What is the difference between a verilog task and a verilog function?
How to calculate the electrical load for a standard telecom BTS shelter and choose the DG set capacity for the same load?
why tertiary winding is used in transformer with diagram?
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
i am completed diploma in ece,and working in ht and lt lines.so is elligible diploma in ece for get electrical C Licence?plse give ur opinion?
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
WHY BREAKER ARE USED IN SUBSTATIONS?
PLEASE SEND ME NTPC RELATED INFORMATION LIKE WHICH TOPICS HAV MORE SCOPE,BOOKS TO READ,CUT OFF...PLEASE.mail at email@example.com
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .