when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??

2136

draw shematic diagram of c/v positioner(smart type)?

2170

how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?

1856

What are different type of instrument cable

2237

What is the diffrence between digital signal processing and discrete signal processing?

1945

give some question relative instrument fitter?

6212

How we calculate orifice plat size???

1474

What is difference between ESD and PLC please Explain me clearly.

4833

A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe

2207

Somebody can explain me about >Critical Loops, calibrations, ESD critical Loop checks, Logic Diagram / Cause & Effect checks for ESD loops,

1638

where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve

1729

What is offset in a control system.

8888

please tell me what is a light up procedure of Cfbc boiler and what it's axuillaries of cfbc boiler?

8620

what is orfics working in main steam line. is it increase pressure, velocity of steam flow and dicrease steam flow rate. or any other

2136

How will you test a transistor with a multimeter?

1043