Answer / sam

Use in steam boilers as the auto control sequence (DCS or
PLC controlled) for the various gas or oil burners.

Answer / k.sreenivasan

1.Burner management is not an analogue control system.
2.It controls the sequential start/stop of burners.
Certain burner management systems combine Boiler Trip
protection also and Furnace safeguard Supervisory system
(FSSS) is one such system used by CE/Alsthom
3. In European designs, the Boiler protection functions are
normally safety system either as SIL-2 or SIL-3. So they
cover all burner sequential start/stop, Boiler Purge etc.
under Burner Management system and MFT (Boiler protection)
is covered under Safety Boiler Protection system deriving
inputs from field and also sending and receiving signals
with BMS.
4.Generally Utility Boiler BMS and Boiler Protections
systems shall satisfy NFPA requirements to prevent
implosions and Explosions

what are the standards used for earthing instruments in the field?

1 Answers  

---

what is thermo coupler and how it works

2 Answers   Tisco,

---

How to find out the current of two motors having same power consumption but different RPM?

0 Answers  

---

What is the difference between compensation and extension cable.

11 Answers   HPCL,

---

How can SmartPlant Instrumentation users take advantage of these global services?

1 Answers  

---

what is function test.

1 Answers   Takreer,

---

Condensation within a sight glass? Would you expect there to be more problems when using a sight glass if there is condensation on the inside or the outside of the glass, and why?

1 Answers  

---

when an eddy current probe is installed inside of a turbine or compressor in case of probe problem same as:crash of head of probe,changing the scale factor because of low measuring gap(physical gap is ok(example=1.14mm)but voltage is reduced(example=-6 volts),is any way to check the probe,when the ohm of probe is ok.thank you,(Karim Tavakoli)

1 Answers  

---

can we copy the software from a transmitter using hht(hart 275) ?

0 Answers  

---

can we use a control valve without positioner

19 Answers  

---

Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plants instrumentation field , which one field is give long life & which one field is best ,I confused a lot And also I'm studying AMIE, can I choose which field from Section B examination?

1 Answers  

---

It is desired to reduce effect of 50Hz pick up in a thermocouple measurement. If a third order LP filter is used for this, what should be its cut off frequency, if gain should be 0.001 at 50Hz.

1 Answers   Honeywell,

---