Answer / l.l

Droop CT is used to control load sharing of the reactive
power between paralleled generators. Its output is mixed
with the phase voltage to result in a signal that will be
proportional to the lagging power factor. This is used to
adjust the excirtation current accordingly so that the
proportion of reactive power is shared between them.

Answer / venkat

Power factor maintain ( Reactive kvar)

Answer / sachin

Droop C T gives pulse to avr for maintain the voltage on
load and reduce the fluctuation of voltage on load

single phase voltage 230 and Three phase voltage 450 why 690 voltage

1 Answers   XYZ,

---

what is deffrence between squirral cage and wound rotor in IM?

0 Answers   ME,

---

What is the difference between circuit breaker and isolator

0 Answers  

---

we are operationing 3NOs 800 Kva generators by singronyus.specialey evening time our panel trip. the panel showing generator earth fault

4 Answers   RRB,

---

how LT meggar works

1 Answers   Essar,

---

why most of the substations are rated in multiples of 11?

4 Answers  

---

What is relation b/w Transmission Lines & Communication Lines ?

2 Answers  

---

If cvt is most advance & effective(economically & stability)so why not use instead of VT(11 kv & 33 kv)?

3 Answers  

---

What is proportional controller?

0 Answers  

---

Differentiate between induced emf and self inductance?

0 Answers  

---

what is AMF panel????????

8 Answers   ACC, Shree Cement,

---

why we r used APFC Panel in industrial area.when P.F. low then wat will be the effect in our system?

10 Answers   ABB, Georgio Rocks, Piramal Healthcare, Zenith Engineering Corporation,

---