What is d diff. btw Online & Offline UPS???
Answers were Sorted based on User's Feedback
Answer / krish
On line UPS means Supply will come from batteries on line
and charging also on line.
In OFF line UPS supply will come from batteries when main
line supply fails.Batteries will charge on line.
| Is This Answer Correct ? | 7 Yes | 1 No |
Answer / mehul
in online ups
supply is coming from ups only it will charge on online &
start when your main supply goes that means you machine or
system will not get tripping
in offline ups
when supply gone ups will start to give power so in that
your system will get small time triping
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / manju
On line ups are use in software company side for ..........Offline ups are used in home need purpose
Online ups means-no interruption
Off line ups means-slightly interruption
| Is This Answer Correct ? | 0 Yes | 0 No |
Besides above mentioned answer (1) I would like to explain some points--
1)Using a online UPS is advantageous for us because of interruption of line supply.As mentioned after main supply fail we use power from battery...........this is a problem :the time it takes to changeover .for example,if our system is much sensitive we may get interruption in getting supply. Normally the the change over time is in order of few millisec.
2) Online UPS is observed to be more economical for higher rated UPS.
| Is This Answer Correct ? | 0 Yes | 1 No |
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
What is the importance of Form B to state Electricity Boards?
Classical power system stability was mainly focussed on rotor angle stability but modern power system stability has more focus on voltage stability.Why?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
What is the Good Earth resistance value of G.I & Cu. Chemical Earthing & Normal Pipe Earthing?
0 Answers ABC, Reliance Life Sciences, TCS,
what is the principle of synchronous motors?
What kind of battries are generaly used with Disel Generator?
How work of capacitor in dc supply...???
what is the relation between size of the anteena and wavelenghth of radiated wave
over frequency is the protection of turbine or alternator?
what is the meaning of trippe time of circuit breaker
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)