Interested to Buy Any Domain ? << Click Here >> for more details...
What is d diff. btw Online & Offline UPS???
- 4 Answers
- 7278 Views
- Emerson, I also Faced
- E-Mail Answers
Answer Posted / abanikanta
Besides above mentioned answer (1) I would like to explain some points--
1)Using a online UPS is advantageous for us because of interruption of line supply.As mentioned after main supply fail we use power from battery...........this is a problem :the time it takes to changeover .for example,if our system is much sensitive we may get interruption in getting supply. Normally the the change over time is in order of few millisec.
2) Online UPS is observed to be more economical for higher rated UPS.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
How can calculate the rating of a servo stabilizer for given a specific load
At the starting of dc motor and syn.motor and induction motor high current flowing through the winding. Due to this the windings burnt out. To avoid this different types of starters are used. But incase of transformer what Will be used (At starting no emf is induced in the primary winding)?
How to find ampere on ht side for selection of cable size ???
What is different bewteen low or high impedance busbar protection scheme
How you calculate the repturing capacity of a HRC fuse
Which type of transformer is used for lighting loads?
Explain the different methods used in the choice of rotor slots for reduction of harmonic torques in an induction motor.
how to revers the direction of single phase motor
is there any current and voltage drop on liquid resistance starter water/soda tank ?
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
how we design a pannel to start 10HP motor with the help of star delta starter?
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
DG Earth Value?
what is relay what is protection & contact multiplying relays where it is used function in brief
If not into production, how far did you follow the design and why did not you see it into production?
