when the size of the cable used for the ht voltage is 300sqmm
then what is the size of the conductor of each phase
Answers were Sorted based on User's Feedback
Answer / prabhakar tiwari
300sqm each conductor because size of con.will same only
kv rating vary always 11,22,33,66kv kv decide insulation
level of cable cond.carry same current.
Is This Answer Correct ? | 4 Yes | 0 No |
What does VVVF stands for in VVVF drive ? How does it differ from VVF drive?
Why the wave trap is put in Y phse only in switchyard?why not in other phases?
1 Answers IAG Automation, REL,
what is the disadvantage of lagging power factor & why ?
Enlist four components of electrive drives.
whats relation b/w motor current & friqency
what is practical efficiency of power transformer..?
What is the Load Capacity of Panther conductor (0.2) and dog conductor (0.1)
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
What is mean by STUB protection?
reason of diode failure in alternator
where is highest transmission voltage is used in india
We use ACB in LT and VCB in HT.But if we use VCB in LT and ACB in HT that what will be the effect on the system or any power range?