when the size of the cable used for the ht voltage is 300sqmm
then what is the size of the conductor of each phase
- 2 Answers
- 4109 Views
- I also Faced
- E-Mail Answers
Answer Posted / vijay shinde
conductor size is 300sqmm
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
anyone knows service engineer in chennai for EDM SPARKING MACHINE.CHMER PULSE CD 60 M.pL GIVE ANY CONTACT NOS
How the over load setting for HT Motors calculated-provided in Numerical Relay
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
Could u pls tell me the NPCIL electrical engineering interview questions for Executive trainee, and also guide me how to face the interview.
please send previous exams question papers
Why we are using only Dyn11 tranformer in distribution system but not using a Dyn1 in distributing system?why not and advantage and disadvantage in both
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
What does quality factor depend on in resonance?
how to find the multiplication factor for digital energy meter and analog energy meter
What is the Surge suppresor? Why using in a UDB's and How it works?
What happens if the Capacitive Voltage Transformer Primary neutral is not earthed. There is a CVT between Transformer and source, and the CVT neutral of the transformer is not earthed, does it effect the transformer while charging or does it effect the transformer charging process.
how to electronic energy metter failed in electomagnectic fild passing in the metter and which thing to defect more on metter.
please send me jindal previous aptitude and technical question and answer.my email id is deep_raj@live.com
what will happen reduce the transformer voltage from 415v to 406v, is it save the energy,? are this methodis good to reduce the energy.?
