Answer / adityabanubakode1234

Even though m300 and m400 is also used in mix design

Answer / gyaneshwar harshwardhan

1:1:2

Answer / guest

M 25 AND 1:2:4

If concrete fails in cube strength as well as non distactive test? what to do? for example grade of concrete is M35, cube strength is 26.1 n/mm2 after 28 days and non districtive test strength is 28.1 n/mm2 after 28 days. i am not distroying the rcc memeber.

3 Answers  

---

how to calculate cube strength in percentage

1 Answers  

---

if mineral admixture add into concrete then what is the differences between full cement concrete & fly ash added concrete of their SP. Gr.?and for the changes of SP. Gr. what is the changes in concrete

0 Answers  

---

how to calculate rate analysis of M25 grade concrete

8 Answers   Nagarjuna Construction, Simplex,

---

How to calculate the wall thickness of building?

2 Answers  

---

---

What is difference between FE-415 and FE-500???

3 Answers   Enercon,

---

Do you know differenence between design mix and nominal mix?

8 Answers   L&T,

---

what is the unit of heat of hydration?

6 Answers   ACC, L&T,

---

a butt weld is specified by

0 Answers  

---

what is water cement ratio in design mix and its percentage in concrete and mortar?

1 Answers   Jain Housing, Shivshakti Sugars, Tulip,

---

What is an ortho mode?

0 Answers  

---

What is the per square fee cost of external development of a multistorey group housing project

1 Answers  

---