What is the maxi. percentage of steel in compression
memeber of C/s area & what is minimum dia for compression
member as per IS 456:2000?
Answer / tusharpatel18
AS per IS 456:2000,Maxi. percentage is 6% of C/S area of
member.However it is limited to 4% in considering spacing
between bars & pouring of concrete.The minimum bar dia for
compression member is 12mm.
| Is This Answer Correct ? | 26 Yes | 0 No |
how many bricks consume for one cft with wastage
how much cement and sand 1:6 plastering
What is the ratio of cement,sand,aggregate of mix m25
steel which is used for reinforcement and structures why they are directly used why GALVANISATION or PRIMER is not done to prevent from corrosion
logical reasoning
what is flexible and rigid footing?
0 Answers IBM, Wah Engineering College,
how to create our resume?
0 Answers Sunraj Construction,
What quantity of 1.0 m3 bricks required?
why we are using stub column..? is it possible to construct steel stub column..?
Can we use 16mm dia bar in place of 12mm dia bar in COLUMNS? (if given dia bar is not available on site)
Kindly tell me a book name to study for BIS exam
how much of the strength comes from post-production curing
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)