Answer / md. zakir hosen

Form Factor is the ratio of R.M.S by Average Value of
current or voltage.
we know,
R.M.S value=0.707
and Avg Value=0636
Therefore,
RMS 0.707
FF=-------=-------=1.11
Avg 0.636


thanking u
z_hosen@yahoo.com

Answer / umang srivastava

its also use to represnt the waveform of any voltage or
current signal. Closer the value to 1.11 (for a sinousoidal
signal), better is the resemblence of the waveform with a
sinuosoidal signal.

carbon zinc cell voltage?

3 Answers  

---

when ID fan will immediately stop through VFD what exactly cause and problem the ID fan

0 Answers  

---

why we used dc supply for field in dg set

0 Answers   Hindusthan National Glass,

---

when we use neutral line as grounding.

1 Answers  

---

why dhyedration test required for transformer oil once in a year

1 Answers  

---

why transformer neutrol is grounding

6 Answers  

---

hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"

0 Answers  

---

What can a fresh(without experience) electrical engineer contribute to NTPC( Or any PSU company) growth?

3 Answers   NTPC,

---

What does the temperature (30 deg or 35 deg celcius) mark on conservator of transformer indicates?

2 Answers   MahaGenco,

---

if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current

0 Answers  

---

WHAT IS THE USE OF ANTIPUMPING CONTACTOR IN HT BREAKERS

8 Answers  

---

What are the difference between these terms ? e.m.f, voltage, potential, potential difference, current etc? what are the difference between these terms ? (electromotive force) e.m.f, voltage, potential, potential difference, reference potential, reference potential difference, current. How can i explain and describe these all terms in single line each and little more explaination too thanks

2 Answers   Siemens,

---