Answer / sivakumar

this case is not possible because it is very low voltage, so
the motor will not rotate because of low voltage.


to find motor current we can use I=P/1.732*v*power factor
the above formula is for three phase

Answer / koti

If motor is in decoupled condition, then it will run and I=10 timews of Ht noload current.

what is gas turbine intercooling ?

0 Answers  

---

What is the required bending radius requied at the time of cable laying?

1 Answers  

---

WHAT MEANT BY SEVICE FOCTOR?

2 Answers  

---

how does circuit breaker works

1 Answers  

---

what are the reasons of low voltage during start the DG?

1 Answers   Godrej, Tata Power,

---

why should we india maintain frequency of 50 Hz.

8 Answers  

---

The slip during plugging operation is given by= A 1-s B 2+s C 1+s D 2-s

0 Answers  

---

Why Batteries are rated as AH i.e AmpereHour,and its formula to converting AmpHour to Amp

4 Answers   Suzlon,

---

why transformer ratings in kva?

99 Answers   Bhel, College School Exams Tests, DOW, Emco, Esab, GE, KCP, PGCVL, Sodexo, TCS, vtps, Wipro,

---

Sir we have 12.5 MVA(110/11KV) transformer (Y-Y) connected,which tripped showing earth fault,when we charged transformer it stood OK ,but on connecting 11 KV feeders it tripped showing earth fault.our service engineers found that the B phase and R phase phase connecting to neutral broken from HV OLTC(on load tap changer),and R phase and Neutral is ok.Dissolved gas analysis shows that accetline content is high,tan delta value is 12.My dout is it is an internal fault of transformer,why REF or diffrential relay is not acted?

1 Answers  

---

which MPU register provides the address from which the next instruction byte is to be fetch?

1 Answers  

---

What is the settings of distance protection relay in 400 kv line

0 Answers   Crompton Greaves,

---