Answer / ganeshkumar

In industrial 3 phase system 1 kva =1.39a
in transfomer give 1 kva =1.33a

What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?

0 Answers  

---

High Voltage out door substation-annual maintenance, things to be considered

1 Answers  

---

1) Explain why we don't link the two earthing system ht and mv on a pole mounted transformer sub-station.

0 Answers  

---

1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.

0 Answers  

---

Explain about technical and non technical losses in distribution system?

0 Answers  

---

what is the use of conservator in a transformer?

6 Answers   L&T, TATA, Tata Motors,

---

What are the different ratings of the fuse units for different distributions at your organization?

3 Answers   TATA, UPPCL,

---

Explain working of servo controlled voltage stabilizer.

3 Answers  

---

If MF is 30000, pt ratio is 110 kV/110 v then what is the ct ratio?

2 Answers  

---

How much pole motor can be desion for 415 volt ,50 hz.Power supply. in pratical condition . Prakash veer singh

5 Answers  

---

can i connect REF and Differencial relay in 1 CT core for transformer protection?

0 Answers  

---

can we load Power capicitors on DG sets?

14 Answers   Neptune, Nimbus, Westin,

---