Answer / simon peter

Bcs torque is directly prop to I drawn by the rotor or armature...

Answer / godwin

if the load increases also the current increases in the
rotor, if the current increases also the heat increase, heat
is a loss, heat increases the motor get damage, so the rotor
current reading is taken to the account.

Answer / aryan

b/c rotor with connect
carban brushes and
stator with not
connected

Answer / guest

when supply is given to stator then flux is induced in the
stator & it varies if current is increase

How may I get the maximum current capacity for a particullar size Alluminum or Copper cable if there is compulsion to use?

0 Answers  

---

What are the condition for parallel operation of transformers?

2 Answers   Alfanar,

---

whatdo mean by chopper fed drives.used for ac drives.

0 Answers  

---

What is the difference between analogue electronics and digital electronics?

2 Answers   PSU,

---

what do you call the last pole on a overhead line near a substation

2 Answers  

---

why we use taping of transformer on HT side?

4 Answers  

---

Why Indian Electricity frequency desined 50 Cycles as developed countrys are using high frequency with low voltage

1 Answers  

---

We have three phase dg of 12kva rating.If the load of each phase is not constant.That means one phase drowning more load than remaining two phase..Then what will happen to dg?

1 Answers   Indotech,

---

why dhyedration test required for transformer oil once in a year

1 Answers  

---

WHAT HAPPENING TO TRANSFORMER???? i have the step down transformer rating 230/12v, power rating something.,,, ok. suppose iam giving 12v to secondary side,what will happen on primary side.,,,

6 Answers   Coastal Energen,

---

please describe the Transformer setting, Motor setting, I/C setting, Tie setting

0 Answers  

---

What is the meaning of electricity? How it is being produced? Can we store the electricity? When we produce electricity what is the capacity of voltage current we are getting? If we need 440 volts how to get it? In case, if we want lower than 440 volts how to change it? Please answer?

1 Answers  

---