Interested to Buy Any Domain ? << Click Here >> for more details...
why rotor current reading is taken & why not stator?
- 4 Answers
- 7129 Views
- I also Faced
- E-Mail Answers
Answer Posted / godwin
if the load increases also the current increases in the
rotor, if the current increases also the heat increase, heat
is a loss, heat increases the motor get damage, so the rotor
current reading is taken to the account.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what are the factors to be considered while design the breaker either HT or LT??
Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?
how much winding resistance of 0.75kw to 12.5kw 3ph sqwiralcage induction motor?
Why should we hire you over the others waiting to be interview?
what are the dimensions for 200 kva transformer plinth (plateform),in which pcc m20 is used..
What we mean by vintage of an engine+Generator?
What is the formula to calculate the rating of power cable for three phase current.
what is interfacing in computer studies?
Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.
the typical output of a solar cell is........
Benifits of 3ph 4 wire metering over 3ph 3 wire
WHAT IS THE TOTAL POWER GENERATION IN CHHATTISGARH?
either water sensor or flow meter,how we observe the water level, f any other equipment are in market ?
Why use in ht motore
What are the components connected in between the power supply coming from an electric pole to HT & LT Panels in a large commercial building or how the power supply connected from Electric pole to Transformer & then to the HT & LT panels of a building? Please send me answers via mail, my id is yogiagarwal@gmail.com. If possible, please give a line diagram.
