Answer / gova

Bus fault level was calculated using symmetrical method.

Answer / kapil dev sharma

current fault level is calculated by the following formula.

Isc= (FLC/%Z)X 100

Isc= Short circuit current
FLC= Full load current
%Z= % Impedence

What is transmission line potential gradiant?

1 Answers  

---

I NEED THE CABLE SIZE. I=800A AND P=315KW

2 Answers   ABC, Wipro,

---

can the measured percentage error during calibration of single phase energy meter be negative?

0 Answers  

---

Which modulation has higher data rates a.fm b.am c.qam d.qpsk

1 Answers   NTDC,

---

in which direction real power and reactive power flow and why???????

3 Answers  

---

It is used or not HT cable single core 630 sqmm in LT 3 phase capacitor bank which is used in PCC(power control center).

1 Answers  

---

Earth Is a very good conductor or very good insulator.? If a good conductor then why current donot flow through small piece f earth and if a good insulator then why we use it as return path in lines.???

6 Answers   L&T,

---

Why we use CT on differant phases of 2ph.PT detection for brush-less static excitation of 3ph.,400v Synchronous Generator? What happen if use CT on same one of VT phase?

2 Answers   Hydropower,

---

how the phase convertor changes the no. of phases

0 Answers  

---

What is the method for testing the differential protection stabilty in generator? When the time of starting What will happen if differentail protection connection wrong means?

0 Answers   JSW,

---

What is the % number of various buses in a typical power system?

2 Answers  

---

Why earthing transformer used in Distribution Sub-Station?

3 Answers  

---