Answer / raj

analog load cell does not gives accurate o/p because there
will be changes in the o/p.so by using digital load cell it
can give accurate o/p and it uses amplifiers fir the
rectification of the signals.

Answer / santosh gawande

in digital loadcell the a/d converter ( bridge amplifier is
near to the strangauges so signal op is correct

how can i communicate with non-national instruments device with pc via labVIEW8.2

3 Answers   Google, Mico, National Instruments,

---

Explain the key components of control loop?

1 Answers  

---

please give me combustion cntrl interlock details? if possidle drawing also?for this one is there any website ?

1 Answers  

---

What are difference between automatic and manual control system?

5 Answers  

---

Isometric drawings are generated during _________________ phase of a project

1 Answers  

---

why the positioner output is 3-15psi

5 Answers  

---

What is a flow meter?

2 Answers  

---

what is the meaing of calibration curve?

3 Answers   HCL, Honeywell,

---

what is dead weight tester and where it is used?.

11 Answers   DuPont, Jain steels,

---

Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.

1 Answers  

---

In oil & gas industries and petrochemical industries, there are classification of zones like zone 0, zone 1, zone 2. Is there any differences in voltages or power supply supplied for the process instruments, control instruments depending on the zones

1 Answers  

---

hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel

1 Answers  

---