In oil & gas industries and petrochemical industries, there
are classification of zones like zone 0, zone 1, zone 2. Is
there any differences in voltages or power supply supplied
for the process instruments, control instruments depending
on the zones
Answer / wael mohamed
yes,according to the frequencies of gas in different areas
Is This Answer Correct ? | 2 Yes | 3 No |
Could you explain to me the enraf (servo gauge) mechanism. How it works ? and how it is working on archimedes theory while it's not immersed into the surface? and how can we calibrate it ? Thanx
In bimetallic temp. Gauges why does metal strip bend? Why do we use low expansion factor metal and high expansion factor metal in bimetaliv strip?
1 Answers Process Control Technologies,
what is pyrometer? which purpose it has to be used?
kindly tell where orifice,nozzle,air foil,ventury used in flow measurement?
what will be the output of a temperature transmitter if temperature is 120 degree celcius?
How to connect PLC to DCS ?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
What is the standard height for stancion supports?
WHEN DO WE GO FOR FMCW TYPE RADAR & PW TYPE RADAR ?
why we are not using the turbine flow meter in the steam service?
What is the standard height for stancion supports? and what is the standard mounting height for different transmitters?
what will happen if transmitter wire get shoted?