A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.

0 Answers   MNC,

---

on which principle control valve works?

3 Answers   Lupin, Reliance,

---

What is the relationship between GAIN and PROPORTIONAL BAND.

1 Answers   Kharafi National, Sabic,

---

how can you set a zero and span of transmitter?

1 Answers   Rockwell,

---

what is droop mode n frequency mode in wood ward governor?

1 Answers   TATA,

---

how to commission furnace ( water heater)

0 Answers   Petrofac,

---

difference between dcs & pld

2 Answers  

---

Is there any interfacing sofware to build communication between a PC and ER300P model L&T make trivector meter via RS485 port which is available in the meter and is there any data acquisition card available to store the acquired data from the meter into the system

12 Answers  

---

What is loop or pigtail in an impulse line?

8 Answers   Qatar Airlines, Qatar Petroleums,

---

What is mean by AC voltage and DC voltage

2 Answers  

---

When we will do simulation for I/P?IF WE DO SIMULATION through which way either series or parallel?

1 Answers   TVS,

---

Where should we terminate the shield and why?

3 Answers   OPaL,

---