Answer / moti rgpv

1-:STAR -DELTA STARTOR
2-:COUPLING WITH INDUCTION MOTOR AND REMOVE THE MOTOR
AFTER GETING 80% TO 90% OF SYNCHRONOUS SPEED
3-:USING DAMPER BARS

Answer / mallikarjun

At first , the synchronous motor is coupled with induction
motor then the synchronous motor will run as a induction
motor and then the d.c supply is given to the field winding
of the synchronous motor ,the rotor will tends to magentic
locking with stator rotating field then that synchronous
motor wii run at synchronous speed

Answer / satya

using pony motors
using damper windings

Answer / kesavulu

Generally Synchronous motors are not self starting motors.
A pony motor is required to rotate and D.C extitation is
also required.Liquified rotary starters are used

Answer / thiru

BUT IN THE OPTIONS THESE ARE NOT THERE
OPTIONS.
1)DOL 2)AUTO T/F
3)ANY ONE 4)NO ANS

Answer / moti rgpv

DOL is also correct BUT IT IS NOT WIDELY USE FOR LARGE
RATING FOR SYN. MOTOR.
SO IN OPCTION DOL IS WRITE

Answer / viswanadh.m

auto synchronous starter

Answer / guest

3 point stater

Answer / ed

Across the line Starter.
with time delay relay or current sensing relay or
speed monitor relay to
energize the field when the motor is close to
synchronous speed

For above 600 volt motors, a Circuit Breaker can be
used instead of a starter.

Answer / ravi

VFD STARTERS.

What is the formula to calculate the no load current of a single & three phase induction motor

0 Answers   HCL, Nokia,

Kindly give the brief explanations for checking 12.5 kvar 440V, 25 KVAR 440V, 12.5KVAR 690V, 25 KVAR 690V capacitors microfarad values. what is the microfarad values for the above four type of capacitors, and give the formula explanations briefly. I know F-50HZ, voltage, and capacitor.

1 Answers  

What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?

4 Answers  

How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?

0 Answers  

1000 W bulb takes 4.16 Amps at 240 volt then what will be the KWH & if i am using 1000 W bulb at 180 Volt the amps will be 5.55 then what will be KWH????????????????

2 Answers  

Whatis the current capacity of 33KV/ 0.433KV transformer on Primary and secondary side/

1 Answers  

what is the working principle of energy saver control panel. please give the complete calculation & theory.

0 Answers   Lupin,

Baud rate is used to descrice...?

2 Answers  

In Energy meter How many rotation Equal to one unit.

3 Answers  

phase association of 3PH L&T static CT meter is wrong. means 1PH & 1 CT connected properly and other 2 voltage and CT's inter changed. what would be the impact in the reading?

3 Answers   KSEB,

who many types of fire explane with exmple

0 Answers   Juniper Networks,

How you will determine the volume of oil in a particular Distribution transformer.

0 Answers