in three phase 11kv transformer (11kv/433v) input( R,Y,B) outpu

in three phase 11kv transformer (11kv/433v)
input( R,Y,B) output (X,Y,Z,N) the connection as follows
1 phase R -open
2phase y connected to both R and y of input]
3phase B- B
what is the output voltage X to N ,Y to N , Z to N

Question Posted / selvaraju

2 Answers
9027 Views
Bescom, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

in three phase 11kv transformer (11kv/433v) input( R,Y,B) output (X,Y,Z,N) the conn..

Answer / pradyumna chandra panda

phase voltage ie. voltage b/w x-n. y-n and z-n is 250 volt each but line voltage b/w x to y = 0 volt y to z= 433 volt and z to x = 433 volt

Is This Answer Correct ?

14 Yes

1 No

in three phase 11kv transformer (11kv/433v) input( R,Y,B) output (X,Y,Z,N) the conn..

Answer / ananyomous

230v

Is This Answer Correct ?

3 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

What are the difference between these terms ? e.m.f, voltage, potential, potential difference, current etc? what are the difference between these terms ? (electromotive force) e.m.f, voltage, potential, potential difference, reference potential, reference potential difference, current. How can i explain and describe these all terms in single line each and little more explaination too thanks

2 Answers Siemens,

What is erection of electrical system?

1 Answers

how freewheeling diode improves the powerfactor

0 Answers

application s to shunt coil

0 Answers

how to calculate the megger values for motors and cables?

2 Answers Adhunik,

why tan delta test is carried out in the power transformer? which parameter are measure?

1 Answers

hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"

0 Answers

Why we use RYB phase sequence?

3 Answers

how many type of of electrical fuse please explan?

9 Answers

Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!

0 Answers

Why no-load primary current is very small as compared to full load current in transformer (as 1% of full load current?

5 Answers NTPC,

what is the transformer rush current?

0 Answers

For more Electrical Engineering Interview Questions Click Here