Answer / m.nandhini

WE CAN MEASURE THE INSULATION RESISTANCE OF DC MACHINE AND
AC MACHINE BY USING INSULATION MEGGAR.IT SHOULD BE OF THE
ORDER OF MEGA OHMS..

EARTH RESISTANCE IS THE RESISTANCE OFFERED
BY THE SOIL.IT SHOULD BE OF ORDER OF OHMS

Answer / yenkatachalm

Megger is used for measuring an insulation resistance of
motor winding of cable etc. which is measured in megaohm.
While earth tester has earth electrodes which are used to
measure eathpit resistance & it is measured in ohm.

megger is used for measuring insulation resistance in mega
ohm range ,while earth tester is used for measuring the
earth resistance which is always less than 5 ohms ie a low
resistance

Answer / surabhi soma sekhar

megger is nothing but an insulation tester, used to measure
(during off-line)the insulation resistance between two
conducting paths and/or a conducting path and a earth,and
usually in MOhms, whereas, an earth tester is an instrument
used to measure the earth resistance with the help of earth
electrodes and usually in Ohms

Answer / shahid

megger is trade name of instrument and used for IR value and
earth tester is used for test the ground conductor
resistance if u see all same but earth tester 3 wire.

Answer / muhammad sherif e s

megger is an instrument which is used for the measurement of
insulation of a particular object . the principle of
ratiometer ohmmeters is particularly used in meggers.
while the earth tester is used for measurement of earth
resistance which will be less than 5ohm

Answer / saumya ranjan lenka

<1>Megger=Meggar megger means insulation resistance(IR VALUES) of any cable ,wire bus bar etc .ITS UNIT IS OHM
<2>
It only measure earth resistance of pit.ITS UNIT IS OHM.
It has two electrode (i.e potential electrode and current electrode) with respect to earth plate under test. The potential electrode will fixed 15mtr from earth plate under test and current electrode 30mtr from earth plate under test.
<3> IF WE ROTATE THE HANDLE OF EARTH TESTER IN OPEN CONDITION THEN THE READING WILL BE 0 OHMS. BUT MEGGER WILL SHOWS INFINITE OHMS.
<4 >MEGGER HAS THREE TERMINALS <i>LINE
<ii> GUARD
<iii>EARTH
<5>EARTH TESTER HAS THREE TERMINAL <i>E(earth plate under test) <ii>P(potential electrode ) <iii>C( current electrode)
BY ER.SAUMYA RANJAN LENKA, STERLING AND WILSON LTD ,DSP SITE WEST BENGAL

Answer / abel tamang

megger is an electrical instrument which measures the resistance of the insulation whereas earth tester is also an electrical instrument by which we measure earth resistance...

Answer / ashish

The term of earth resistivity expressed in ohm centimetre is one basic variable affecting resistance to earth of an electrode system, The megger is measuring an insulation resistance between any phase & earth or ground where as earth tester is used.

Answer / er vimal

Megger is a ratio type instrument which insulation resistance measured in mega ohm

Earth tester is a indicating type instrument which earth resistance measured in ohm between two point

Answer / kabir0921

Originally The term Megger is wrong.Megger is the name of company.

Single phase and threephase power calculation

0 Answers  

WHY AIR COMPRESOR IS STARTED UNLOADED

3 Answers  

sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.

0 Answers  

why we calculate only 11kv 33kv and 132kv ... why not 10kv 20kv 45kv?

3 Answers   Bhel, ISMT,

watt meter have 4 terminals what there name??? and what theses 4 terminals indicates ?? and why 2 terminals are short circuited??

1 Answers  

Maximum efficiency occurs in electrical machines is at i)Full load,ii)50% of full load,iii)Near full load,iv)None of these

1 Answers   IFFCO,

what is the voltage level which is used in transformer short circuit test

1 Answers  

Why we Specify Transformer rating 433 V Instead of 415V ?

8 Answers   ABB, ERA, Uddans,

why 3 phase is converted into 2 phase using electronics circuit why not 2 phases are diresctly putted from the 3 phase transformer??

0 Answers   Descon,

if 40 watt bulb has higher resistance then a 100watt bulb then according to joul farmula p=I^2R the 40 watt bulb more power consume then 100 watt bulb.

5 Answers  

In zero voltage we can pass supply to our body means we cant get shock its true ? how we can do it ?

4 Answers  

what use marshalling kishock in power transformer?

2 Answers